Table of Contents
Advertisement
KTD-00629-K
4.11 USB Connector (USB)
The ICH4 contains an Enhanced Host Controller Interface (EHCI) compliant host controller that supports
USB high-speed signaling. High-speed USB 2.0 allows data transfers up to 480 Mb/s which is 40 times
faster than full-speed USB. The ICH4 also contains three Universal Host Controller Interface (UHCI)
controllers that support USB full-speed and low-speed signaling with a total of 6 ports.
All six USB ports supports USB2.0 and USB1.1 and all ports supports Over-current detection.
USB Port 0 and 3 are supplied on the combined ETHER1, USB0, USB3 connector. USB Ports 1 and 4 are
supplied on the FRONTPNL connector; please refer to the FRONTPNL connector section for the pin-out.
USB Ports 2 and 5 are supplied on the USB25 connector.
USB Port 0, 1, 2 and 3 supports USB Legacy mode.
4.11.1 USB Connector 0/3 (USB0/3)
USB Ports 0 and 3 are mounted together with ETHER1 ethernet port.
Pull
Note
U/D
Ioh/Iol
1
-
-
1
-
-
Note 1: The 5V supply for the USB devices is on-board fused with a 1.5A reset-able fuse. The supply is
common for the two channels. SB5V is supplied during power down to allow wakeup on USB device activity.
In order to meet the requirements of USB v.1.1 standard, the 5V input supply must be at least 5.00V.
Signal
Description
Differential pair works as Data/Address/Command Bus. Legacy USB is supported by
USB0+ USB0-
both USB0 and USB3.
USB3+ USB3-
USB5V
5V supply for external devices. Fused with 1.5A reset-able fuse.
4.11.2 USB Connector 2/5 (USB25)
The pinout of the USB connector USB25 (no Shroud) is as follows:
Pull
Note
U/D
Ioh/Iol
-
-
-
-
-
-
Signal
Description
Differential pair works as Data/Address/Command Bus. Legacy USB is supported by
USB2+ USB2-
USB2.
USB5+ USB5-
USB5V
5V supply for external devices. Fused with 1.5A reset-able fuse.
786LCD/mITX Family
Public
User Manual
Type
Signal
1
PWR
5V/SB5V
IO
USB3-
1
PWR
5V/SB5V
IO
USB0-
Type
Signal
PWR
5V/SB5V
IO
USB2-
IO
USB2+
PWR
GND
KEY
Date: 2009-10-13
PIN
Signal
2
3
4
GND
USB3+
2
3
4
GND
USB0+
PIN
Signal
1
2
5V/SB5V
3
4
USB5-
5
6
USB5+
7
8
GND
10
NC
Page
38 of 77
Pull
Type
Ioh/Iol
U/D
PWR
-
-
IO
PWR
-
-
IO
Pull
Type
Ioh/Iol
U/D
PWR
-
-
IO
IO
PWR
-
-
-
-
Note
Note
Advertisement
Table of Contents
