Solaris Os Issues - Fujitsu SPARC ENTERPRISE T5440 User Manual

Solaris OS Issues

TABLE A-2
Fixed Solaris OS Issues
TABLE A-2
CR ID Description
6588550 The prtdiag -v command and the prtpicl
command are slow and could thus appear to
hang. These command could take up to five
minutes to complete.
6596503 The output of the prtpicl command used with
the -v option might show CPU cores or strands
with an OperationalStatus of enabled when, in
fact, they do not exist.
6552999 If the verbose (-v) option is specified for the
control domain prtdiag command, additional
6731560
environmental status information will be
displayed.
If Control-C is issued to interrupt the output
of this information, the picld(1M) daemon may
enter the state in which environmental status
information is no longer supplied to prtdiag. If
it does, additional environmental data will no
longer be displayed.
6702351 If cfgadm -c unconfigure is executed
repeatedly in sequence, the blue LED may
remain off.
6718696 The information displayed by the prtdiag
command may have abnormalities when
memory becomes degraded.
For example, it may show a single 4-GB DIMM
to be 5.33 GB.
52 SPARC Enterprise T5440 Server Product Notes • November 2009
lists the Solaris OS issues that have been fixed.
Workaround
Note - Fixed in Solaris patch ID 138502-01 or
later.
Execute it again after a few minutes.
Note - Fixed in System Firmware 7.1.8.a or
later.
Use the output from the prtdiag or
prtpicl -c cpu commands, which do show the
correct information.
Note - Fixed in Solaris patch ID 138082-01 or
later, and 139502-02 or later.
See "If prtdiag Is Canceled, Subsequent
prtdiag Executions May Fail to Display Status
Information (CR 6552999, 6731560)" on page
Note - Fixed in Solaris patch ID 139555-03 or
later.
Since some time is required for the blue LED to
light, do not execute the command repeatedly in
sequence.
Note - Fixed in System Firmware 7.2.2.e or
later.
None.
53.