Fujitsu SPARC ENTERPRISE T5440 User Manual page 66

Fixed ILOM Issues (Continued)
TABLE A-3
CR ID Description
6781815 After the ILOM reset or the power cable removal
and insertion, when the server powered on,
Solaris OS startup at the ok prompt of OBP
(OpenBoot PROM) using the boot command
may fail.
[Error output example]
{0} ok boot
ERROR: All device paths in
boot-device have failed. (*)
{0} ok
It cannot refer to the device paths that
configured in the OBP environmental variable
boot-device and fails to start Solaris OS.
6694693 ILOM allows only two privileges: Administrator
and Operator. Therefore, the following text
about the ALOM CMT userperm command in
the manual is inappropriate.
If one of [c], [u], [a], and [r] is set, Administrator
authority will be in effect. If nothing is specified,
Operator authority will be in effect.
<Integrated Lights Out Manager 2.0 Supplement>
userperm [username] [c][u][a][r]
6579390 After disabling a DIMM, the OpenBoot PROM
banner does not show a decrease in the amount
of memory.
6656116 If the DIMM module fails, the MCU will be
disconnected, and an error message might be
output to the console.
For an example of the message, see
Be Disconnected in DIMM Module Failure (CR
6656116)" on page
56 SPARC Enterprise T5440 Server Product Notes • November 2009
"MCU Might
57.
Workaround
Note - Fixed in System Firmware 7.2.2.e or
later.
After the ILOM reset or the power cable removal
and insertion, when you power on the server,
check the OBP environmental variable.
Especially, in case the OBP environmental
variable use-nvramrc? has been set to true, it
is necessary in advance of starting the OS to see
the ok prompt and check that use-nvramrc?
has been set to true and then execute the boot
command.
[Confirmation example]
{0} ok printenv use-nvramrc?
use-nvramrc? = true
{0} ok
Note - Fixed in System Firmware 7.2.2.e or
later.
None
Note - Fixed in System Firmware 7.2.2.e or
later.
If you manually disable any CPU or memory
resource with the ASR commands while the host
is powered on, you must power cycle the host to
complete the disabling of the resource.
After the power cycle, the resource will be
disabled, and the proper information will be
displayed in the banner.
Note - Fixed in System Firmware 7.1.8.a or
later.
Identify and replace the faulty DIMM module.