Installing The Propeller; Installing The Antenna - Hangar 9 Advance 40 Instruction Manual

Installing the Propeller

You will need to purchase the appropriate propeller for your
particular engine. If you have a .40 size engine, a 10 × 6
propeller will work. For a .46 size engine, an 11 × 6 propeller is
the correct propeller.
Unscrew the prop nut from the engine and install the spinner
back plate, then the propeller, then the prop washer. Securely
tighten the prop nut using a 4-way or crescent wrench. Now
install the spinner using the two Phillips head screws provided.

Installing the Antenna

Unchord the receiver and the antenna wire. Locate the antenna
tube included with the Advance 40. Pull about 1'' of antenna wire
past the end of the antenna tube and secure by wrapping a
rubber band around the tube to hold the antenna in place. Insert
the antenna tube through the back of the fuselage. Tuck the front
of the tube behind the servos in the fuselage.
26
Note: You can thread the antenna through the tube, but this
is a time consuming process that's not necessary.
Rubber banding the antenna to the tube is just as
effective, however it's not as neat.