Section 4: Installing The Propeller On The Evolution Trainer Engine - Hangar 9 Extra Easy XE2 Instruction Manual

Step 3-3
Step 3. Connect the rudder and elevator pushrod clevises to
the pre-installed control horns. Install the clevises into the hole
furthest away from the control surface (see illustration). Secure
Section 4: Installing the Propeller on the
Evolution Trainer Engine
Step 1. Remove the prop nut and washer from the Evolution
engine, noting the position of the washer and flywheel.
The rudder pushrod
is positioned above
the horizontal stabi-
lizer.
each clevis to the control horn by snapping the clevis pin into
the hole. To prevent the clevises from accidentally opening in
flight make sure the clevis keeper is slid up onto the clevis.
Step 2. Locate the spinner and three self-tapping screws
included in your Xtra Easy 2™ RTF kit.
Clevis Keeper
Clevis Keeper
9