Physical Installation; Location And Orientation - Martin Extube User Manual

Physical installation

Warning! Read "Safety Information" on page 3 before installing the
Extube.
Warning! The safety and suitability of lifting equipment, installation
location, anchoring method, mounting hardware and electrical
installation is the responsibility of the installer. All local safety
regulations and legal requirements must be observed when
installing and connecting the Extube. Installation must be carried
out by qualified professionals only.
Contact your Martin supplier for assistance if you have any
questions about how to install this product safely.

Location and orientation

Warning! The Extube must be clamped onto a a DIN top-hat rail that
is securely anchored to a suitable flat surface. Ensure that the
supporting structure can bear the weight of all installed devices plus
an adequate safety margin.
Warning! If no diffuser filter is installed, make sure that it is
impossible for LEDs to be viewed from a distance of less than 40 cm
(16 inches).
If the diffuser front is installed, there is no eye hazard at any distance.
important! Make sure that there will be at least 10 cm (4 inches) of
free space and unrestricted airflow around the Extube.
The Extube can be installed outdoors. It has an IP rating of 65 and is
designed to withstand rain and other low-pressure water projections, but:
• Do not expose it to high-pressure water jets from any direction.
• Do not immerse it in water or any other fluid.
• Do not install it in a location where flooding may occur.
If installing in an enclosed area, make sure that water can drain away from
the installation area at least as fast as it can enter it.
The Extube requires free and unobstructed airflow around it to ensure
adequate cooling:
• Do not cover the fixture or locate it in an unventilated space.
• Allow 10 cm (4 inches) free space around the fixture.
Physical installation 11