Drive Axle Set Replacement - Matrix r7xi-02 Service Manual

9.23 DriVE AxlE SET rEPlACEMENT

note: a matrix special tool is needed to correctly replace a drive axle. order part
1) Turn off the power and disconnect the cord from the machine.
2) Remove the front covers from the machine as outlined in Section 9.15.
3) Remove drive belt as outlined in Sections 9.19.
4) On the left side of the frame, remove the retainer clip that holds the drive axle bearings in the frame (Figure A).
5) Use a hammer to hit the screw until the drive axle assembly is loose in the frame, and remove it (Figure B).
6) Install the tool into the hole in the frame and use a rubber mallet to hit the end of the tool until the bearing can be removed from the frame
(Figure C & D).
7) The drive axle should have come with an iron plate installed (Figure E).
8) Assemble the Matrix tool as shown in Figure F.
110
CHAPTEr 9: PArT rEPlACEMENT gUiDE
figUrE A
figUrE C
figUrE E
# 1000323981 from matrix cts at 866-693-4863 ext 3.
figUrE B
figUrE D
figUrE f