SAVE THESE INSTRUCTIONS DANGER! When using Matrix Cycles, basic precautions should always be followed, including the following: TO REDUCE THE RISK OF ELECTRICAL SHOCK: Read all instructions before using this equipment. It is the responsibility of the owner to ensure that all users of this equipment are adequately informed of all warnings and precautions.
If the user does not follow systems, or any other item should lose power when you perform this test. these grounding instructions, the user could void the Matrix limited warranty. Non-looped (isolated) neutral/grounding means that each circuit must have an individual...
ASSEMBLY UNPACKING Page Upright Cycles Unpack the equipment where you will be using it. Place the carton on a level flat surface. It is recommended that you place a protective covering on your floor. Never open box when it is on its side. IMPORTANT NOTES During each assembly step, ensure that ALL nuts and bolts are in place and partially threaded.
Hardware Upright Cycle Assembly Bolt Flat Washer TOOLS REQUIRED: F 4 mm Allen Wrench F 6 mm Allen Wrench F 8 mm Allen Wrench F Flat Wrench (15mm/17mm 325L) F Phillips Screwdriver PARTS INCLUDED: F 1 Main Frame F 1 Rear Stabilizer Tube F 1 Front Stabilizer Tube F 1 Rear Frame Handle F 1 Rear Frame Cover...
Page 8
Hardware Recumbent Cycle Assembly Bolt Flat Washer TOOLS REQUIRED: F 4 mm Allen Wrench F 6 mm Allen Wrench F Flat Wrench (15mm/17mm 325L) F Phillips Screwdriver PARTS INCLUDED: F 1 Main Frame F 1 Rear Stabilizer Tube F 1 Front Stabilizer Tube F 1 Rear Frame Handle F 1 Rear Frame Cover F 1 Console Mast...
Page 10
Hardware Hybrid Cycle Assembly Bolt Flat Washer TOOLS REQUIRED: F 4 mm Allen Wrench F 6 mm Allen Wrench F 8 mm Allen Wrench F Flat Wrench (15mm/17mm 325L) F Phillips Screwdriver PARTS INCLUDED: F 1 Main Frame F 1 Rear Stabilizer Tube F 1 Front Stabilizer Tube F 1 Rear Frame Handle F 1 Rear Frame Cover...
BEFORE YOU BEGIN POWER LOCATION OF THE UNIT If the equipment is powered by a power supply, the power must be plugged into the power jack, which is located in the front of the equipment near the Place the equipment on a level and stable surface away from direct sunlight. stabilizer tube.
PROPER USAGE To determine proper seat position, sit on the seat and position the ball of your foot on the center of the pedal. Your knee should bend slightly at the furthest pedal position. You should be able to pedal without locking your knees or shifting your weight from side to side. Adjust pedal straps to desired tightness. USING THE HEART RATE FUNCTION The heart rate function on this product is not a PULSE GRIPS...
5. Ensure that any person(s) making adjustments or performing maintenance or repair of any kind is qualified to do so. MATRIX dealers will provide Clean underneath the cycle, following these steps: service and maintenance training at our corporate facility upon request.
146.8 x 65.4 x 156.8 cm / 57.8” x 25.7” x 61.7” * Ensure a minimum clearance width of 0.6 meters (24”) for access to and passage around MATRIX equipment. Please note, 0.91 meters (36”) is the ADA recommended clearance width for individuals in wheelchairs.
Need help?
Do you have a question about the Performance Upright Cycle and is the answer not in the manual?
Questions and answers
How to use Matrix Model LED-C exercise bike