Lower Control Board Replacement - Matrix r7xi-02 Service Manual

9.17 loWEr CoNTrol BoArD rEPlACEMENT

1) Remove the left side front cover as outlined in Section 9.15.
2) Disconnect the 5 wire connections to the lower board (Figure A).
3) Remove the 2 screws holding the lower control board to the frame (Figure B), and remove the lower control board.
4) Reverse Steps 1-3 to install a new lower board. Figure C shows the electrical connections to the lower board.
2 Pin Connector
from the Battery
6 Pin Connector from
the DC power source
5) Test the bike for function as outlined in Section 9.26.
104
CHAPTEr 9: PArT rEPlACEMENT gUiDE
figUrE A
figUrE C
figUrE B
8 Pin Connector
from the Console
2 Pin Connector
from the ECB
3 Pin Connector from
the Generator