Setting Up The Ocp - GRASS VALLEY OCP 400 User Manual

Menu
Diagnostics
page 1
Diagnostics
page 2
Diagnostics
page 3
Diagnostics
page 4
Diagnostics
page 5
Diagnostics
page 6

3.3 Setting up the OCP

Various aspects of the OCP can be set to suit your work methods. To open the menu which
lets you set up these preferences proceed as follows:
– Push the SETUP button to open the menu.
– Push the SELECTION button to choose the OCP submenu.
– The first page of the OCP setup menu appears. Use the NEXT button to find the page
20
Selections Function
Camera Camera type number
Gen Lock GenLock Status
BS Type XCU/Base Station type
Cable Triax status diagnostics
Cam Pack. Camera package version
Version Camera package version
BS Pack. XCU/Base Station package
version
Version XCU/Base Station package
version
Cam SW Camera Software 12NC
Status Camera Software Status
BS SW XCU/Base Station Software
12NC
Status XCU/Base Station Software
Status
OCP Appl Application software version
OCP BootSw Boot software version
OCP FirmW Firmware version
OCP Type OCP device type
Ethernet MAC OCP Ethernet MAC address
Address
Link Type Ethernet link speed
Link State Ethernet connection status
Ser Recv
Ser Sent
Frame Err
Sum Err
with the item you wish to change and then select this item with its correpsonding
selection button.
Level Possible values
S No camera, [Camera Type]
S Locked, Not Locked, No sync
S LDK4502 .. LDK 4430
S No camera, DC Power, Short, etc
S Last 4 digits of Package 12nc
S v0x.0y
S Last 4 digits of Package 12nc
S v0x.0y
S
S
S
S
S v04.01
S vXX.XX
S vXX.XX
S OCP 400/00 or OCP 400/10
S Mac-address is displayed as:
XX:XX:XX:XX:XX:XX
S 10 Mbit/100 Mbit Full/Half Duplex
S Connected / Not Connected
F
F
F
F
OCP 400 Operational Control Panel User's Guide (v12.0)
Chapter 3 - Setup