Winter Mode - Datatool S4 User Manual

'Panic/locator' feature
Press and hold the BLACK button of the remote for
3 seconds with the ignition switched OFF to enter
'panic/locator' mode.
The siren will sound and the indicators will flash until
any button is pressed on the remote control to turn the
panic/locator mode off.
When triggered, the alarm system reverts to the
original state held before the button was pressed to
activate the panic/locate mode.
10m (max)
Press and hold BLACK button for three seconds

Winter mode

The purpose of this mode is to enable you to leave
the machine for long periods of time with the alarm
drawing an absolute minimum current (250µA) from
the machine's battery. In this mode the alarm system is
no longer active and it leaves the machine immobilised
only.
Should you decide to place the machine in this state,
we strongly advise you to use further measures to
protect your machine with quality physical security
such as the Thatcham approved lock & chain in
conjunction with a Thatcham approved ground anchor.
NOTE: The machine's battery will still naturally
discharge over time so we advise you to check its
condition periodically.
Entering 'Winter' mode
From the disarmed state, press both buttons on the
transmitter for 10 seconds with the ignition ON until
you hear a beep, after the ignition is switched OFF
the alarm unit will go into winter sleep mode. The unit
will now be completely shut down leaving the machine
immobilised and current usage below 250µA.
Press GREY
button
Ignition
OFF
Exiting 'Winter' mode
To re-activate the alarm system the ignition has to
be switched ON and the alarm will give a series of
increasing rate beeps which last for 5 seconds.
Within this time press the GREY button on the remote
control or the alarm system will trigger.
Once the unit has woken up it will come back as a
fully armed alarm/immobiliser. This ensures that if the
machine is attacked by a third party, it is fully protected.
We would again advise you on the benefits of using the
Datatool Smart Charger to maintain the condition of
your battery during extended stand up periods.
NOTE: Scorpion Automotive Ltd. cannot be held
responsible for batteries which have failed due to
mistreatment.
Ignition
One flash,
one beep
one beep Press both buttons
for 10 seconds
ON
9