Sleep Mode; Hazard Warning Lights - Datatool S4 User Manual

'Sleep' mode
All alarm systems use a small amount of current
during operation and if the machine is to be left for an
extended period with the alarm armed we recommend
the use of a battery conditioner (such as the Datatool
Smart Charger) to maintain the battery charge level.
To minimise the impact of the alarm on the battery
condition, the Datatool
®
procedure to reduce the current consumption of the
system as the motorcycle battery starts to discharge.
This system reduces the risk of damaging the
machine's battery through being left in a discharged
state. The levels of sleep are as follows:
Level 1
Approx. 11.5 Volts
• When the alarm is armed the LED flashes once
every 10 seconds.
• Still able to Arm/Disarm the alarm from the remote
control.
• Alarm will passive arm after 45 seconds of being
unset or ignition being turned off.
• Panic facility is active.
• Tilt sensor is active.
• Shock / nudge sensor is active.
Level 2
Switching Point 10.5 Volts
• The LED flash rate reduces to once every 30
seconds.
• Siren bleeps every 60 seconds to warn of low battery
condition.
• Shock / nudge sensor is off.
• Tilt sensor is active for one cycle.
• On-board receiver is switched off and the remote will
not turn off the alarm until the ignition is turned on.
8
S4 includes a three level sleep
Level 3
Switching Point 9.8 Volts
• The LED is switched off (does not flash).
• The low battery siren bleep is disabled.
If you wish to disarm the alarm in sleep levels two or
three turn the ignition on and press the GREY button
on the remote control.

Hazard warning lights

This is a hazard light warning feature for motorcycles
even if they do not have a hazard-warning switch.
Pressing both the GREY and BLACK buttons of the
remote control for 3 seconds when the ignition is OFF
and the alarm system is armed will start the hazard
warning lights.
NOTE: If the motorcycle battery voltage is too low to
maintain this feature, the lights will flash 5 times and
then stop.
To turn off the hazards either press both buttons again
for 3 seconds (leaves the system armed) or press the
GREY button to disarm the alarm system and turn off
the hazard lights.
NOTE: For safety reasons the hazard light feature
cannot be used with the ignition turned on.
10m (max)
Press and hold GREY and BLACK at the same time