Disarming The System - Datatool S4 User Manual

Arming the system without the
movement sensor ('Ferry' Mode).
To arm the alarm system but have both the movement
and nudge sensors turned off; press the BLACK
button within 10 seconds of arming the system with
the GREY button.
The indicators will flash twice to indicate the alarm
has been armed and then indicators will flash three
further times to confirm the movement sensors have
been turned OFF.
The system will still have immobilised the machine
(except with S4 Green model) and the alarm will react
if the machine is hot-wired, the supply to the alarm
is tampered with or one of the trigger switches is
activated.
If you press the BLACK button after more than 10
seconds of arming the alarm nothing will happen
and the alarm will still remain fully armed with the
movement sensors ON.
This process has to be carried out EVERY time you
wish the alarm to be in 'Ferry' mode.
NOTE: If you have selected full passive arming and
wish to have the alarm in 'Ferry' mode you must arm
the alarm as stated above. The alarm cannot be put
into 'Ferry' mode after it has been 'PASSIVE' armed.
Press to arm
Press within 10
seconds
6
10m (max)
2 flashes
10m (max)
3 flashes

Disarming the system

To disarm the system from the armed state, simply
press the GREY button on the remote control.
The unit will then flash the indicators once to indicate it
has been disarmed.
Turn the ignition on within 45 seconds or the system
will automatically re-arm in the same state as it was
armed prior to disarming.
NOTE: Each time the system is disarmed the LED will
flash to signify the total number of remote controls
coded into the system. This ensures you will always
know you are in possession of all remote controls
capable of operating your system.
If you find there are extra, unknown remote controls
coded into the alarm, your dealer can exclude these
from the unit. Your dealer may levy a small charge at
their own discretion for this service.
10m (max)
Press to disarm Flash once, LED flash
according to number of
remote coded to the alarm