Datatool S4 User Manual page 15

Changing the passive arming
settings (passive immobiliser or
full passive arming)
1. Once you have located the passive arming
selection (Switch 2), press BOTH buttons of the
remote control to enter the switch. A triple beep
will be heard confirming you have entered the
switch.
2. The factory default setting for this switch if OFF. If
you wish to turn it ON (full passive arming of the
alarm and immobiliser) press the GREY button
of the remote control and the system LED will be lit
confirming you have chosen full passive arming.
If you wish to return to passive immobiliser only,
press the BLACK button of the remote control and
the LED will be OFF to confirm the setting.
How to remove your machine's battery
You can remove the battery at any time when the
system is 'immobilised only' or in 'winter mode'.
Winter mode also stops the remotes operating the
system making this setting better.
If the alarm system has been armed, the internal
battery back-up system is also turned on and
disconnection of the battery will cause the alarm
system to sound.
If you have changed the standard default setting of the
alarm to full passive arming the easiest way to remove
the machine's battery is to select 'winter mode' prior to
removal of the battery.
3. Once you have set the alarm to your arming
preference, press BOTH buttons of the remote
control to accept the setting, a double beep will be
heard and you will return to the software switch
selection.
To exit software switch selection simply turn the ignition
OFF completely.
Press GREY button
Disconnect
battery
Ignition
ON
Press both buttons
for 10 seconds until
beep
Ignition
OFF
15