Subscribe to Our Youtube Channel
Related Manuals for Datatool EVO PRO
Summary of Contents for Datatool EVO PRO
- Page 1 Installation Guide Datatool is a brand of Scorpion Automotive www.datatool.com | 01257 249928 Scorpion House, Drumhead Road, Chorley PR6 7DE P/N 02000147 Rev.01 - 07/22...
-
Page 2: Table Of Contents
2.0 - ALARM POSITIONING CONTENTS 1.0 - PRELIMINARY ADVICE............PAGE 02 2.0 - ALARM POSITIONING............PAGE 03 Do not install the alarm unit in this 3.0 - ACCESSORIES POSITIONING..........PAGE 04 position as water ingress over time 3.1 - Electronic key receptacle............PAGE 0 may seep through the rubber 3.2 - Contact switch (Thatcham Requirement)...... -
Page 3: Accessories Positioning
3.0 - ACCESSORIES POSITIONING 4.0 - ALARM UNIT SEALING 3.1 - Override key receptacle To seal the alarm, position the The receptacle with built-in LED must be installed where it can readily be seen rubber cap over the external edge and accessed by the user. -
Page 4: Alarm Positioning For Maximum Sensitivity
5.0 - ALARM POSITIONING FOR MAXIMUM SENSITIVITY To ensure correct operation of the built-in motion sensor, install the alarm as illustrated below. Figure 4: motion sensor operation with siren facing sideways (only for vehicles with a side stand). The alarm can be fitted on either the right or left side of the vehicle as long as the siren is turned towards the right side of the vehicle (opposite to the stand). -
Page 5: Electrical Connections
7.0 - WIRING DIAGRAM AND PINOUT 6.0 - ELECTRICAL CONNECTIONS WIRE COLOR CONNECTION Black marked “M” Connect to battery negative terminal lack marked “B1” :Starter immobilization : Black marked “R” Connect to battery positive terminal Brown Earth for override key : Orange Connect to right turn indicator light 3 Black marked “M”... -
Page 6: Double Engine Immobilization
8.0 - DOUBLE ENGINE IMMOBILIZATION 8.1 Electronic ignition 8.2 - Grounded Wire Example N.1 Example N.2 Example N.1 Example N.2 BLACK H1 BLACK HB BLACK H1 BLACK HB N.C. N.C. N.O. N.O. BLACK B1 BLACK B BLACK B1 BLACK B COM. -
Page 7: Pairing New Devices
9.2 - Without BROWN/GREEN wire ground connection 9.0 - PAIRING NEW DEVICES To pair a new device, proceed as follows: 9.1 - With BROWN/GREEN wire ground connection The alarm is supplied with 2 remote controls and 1 override key but other Make sure passive immobilisation is not active. -
Page 8: Programmable Features
After pressing both buttons simultaneously (step 4), program the features 10.0 - PROGRAMMABLE FEATURES according to your needs. To either enable or disable one of the programmable features proceed as indicated hereafter. TO ENABLE TO DISABLE NB: Remember to ALWAYS arm and disarm the alarm before programming. Press button 2 Press button 1 Button 1: TO ENABLE... -
Page 9: Remote Control
12.0 - REMOTE CONTROL 13.0 - WASTE ELECTRICAL AND ELECTRONIC EQUIPMENT The remote control has 2 different function buttons each of which corresponds The present device falls within the field of application of the current WEEE to a control signal that activates a selected action according to the operational Directive.
Need help?
Do you have a question about the EVO PRO and is the answer not in the manual?
Questions and answers