Datatool S4 User Manual page 12

Disarming the system with your PIN
If the transmitter is lost or damaged, or the transmitter
battery is flat, the system can be overridden by your
chosen four digit PIN (Personal identification Number)
used in conjunction with the ignition switch. The PIN
procedure can only be used after a full alarm reaction
has been initiated.
The procedure is as follows: -
1. Turn the ignition ON to initiate an alarm reaction,
(this will be immediate if the alarm is armed, or
after 10 seconds if the immobiliser only is armed).
2. The alarm will sound for 30 seconds and the
indicators will flash for 30 seconds. Do not turn
the ignition OFF during the sounding phase.
3. When the alarm reaction stops, the motorcycle LED
will be on constantly for 5 seconds. During this
5 second period, turn the ignition OFF and ON.
4. The override procedure will start immediately,
indicated by rapid flashes of the LED for
3 seconds which beeps as detailed within the PIN
entry section above.
5. Count the number of slow flashes from the LED or
beeps from the siren until it equals the first digit
of the PIN code and then turn the ignition OFF and
ON. Again if you have selected zero as your first
PIN number you must turn the ignition OFF and ON
immediately after the rapid flashes stop.
6. The system will then return to the rapid LED flash
sequence for 3 seconds and then go to slow
flashes/beeps. Count the number of flashes or
beeps from the siren until it equals the second
digit of the PIN code and then turn the ignition
OFF and ON.
7. Repeat the sequence to enter the 3rd and 4th
PIN number.
12
If entered correctly, the alarm will disarm and the
motorcycle indicators will flash once.
NOTE: As soon as the alarm system is disarmed, the
passive arming alarm (if selected) and passive arming
immobiliser periods will begin. Therefore, the ignition
must be switched ON within the 45 second arming
period, otherwise the alarm system (if selected) and
the immobiliser will passive arm.
Entering an incorrect PIN code will initiate a full alarm
reaction.
If an incorrect PIN code is entered three times the unit
cannot be disarmed by the PIN number for 2 minutes.
If you have done this, the LED will give double flashes
when the third incorrect code is entered until the lock-
out time has expired.
Initiate full alarm reaction by turning
the ignition ON and leaving it ON
Full Alarm Reaction
for 30 seconds
ENTER YOUR INDIVIDUAL 4 DIGIT PIN
To enter To enter
first digit second digit
One beep & flash Ignition ON
Ignition OFF four beeps & flash
Ignition OFF
1000 1400
LED
YOU NOW HAVE 45 SECONDS TO TURN THE IGNITION ON
AND START THE MOTORCYCLE
Until your transmitter is replaced or repaired, this procedure must be
repeated to disarm the system every time it arms.
Entering an incorrect PIN will initiate a full alarm reaction.
When alarm reaction stops
Motorcycle LED
will be CONSTANT
for 5 seconds
During this 5 second LED on bikes flashes
interval turn ignition rapidly for 3 seconds
OFF and ON again
To enter To enter
third digit fourth digit
Ignition ON Ignition ON
two beeps & flash six beeps & flash
Ignition OFF Ignition OFF
1420 1426
If entered correctly the alarm
will disarm and the motorcycle LED
will flash once