Lancom 1811 User Manual page 21

LANCOM 1821+
Wireless ADSL
Top panel
The two LEDs on the top panel provide a convenient overview of the most
important status information, especially when the device is installed vertically.
³
This LED provides information on the device's operating state. After being
Power
switched on, it blinks green during the self-test. The LED then shines con-
stantly to indicate operational readiness, unless an error is detected as indi-
cated by a code blinked in red.
Off
Green
Green
Red/green
Red

LANCOM 1811 Wireless DSL – LANCOM 1821+ Wireless ADSL
³ ·
´ ²
Power
Online
Device switched off
Blinking Self-test after power-up
On (perma- Device operational
nently)
Blinking alter- Device insecure: Configuration password not set
nately
Blinking Charge or time limit reached
The power LED blinks alternately in red/green until a configuration
password has been set. Without a configuration password, the confi-
guration data in the LANCOM are unprotected. Normally you would
set a configuration password during the basic configuration (instruc-
¶ º ¾ µ ¸
Chapter 2: Installation
1821+ Wireless ADSL
21