Table of Contents
Advertisement
Finally, you should know whether your telephone provider transmits an
ISDN connect-charge pulse. This signal can be used LANCOM Router for
connect-charge budgets and the accounting function.
3.1.5
Connect charge protection
Connect charge protection blocks DSL connections that go beyond a previ-
ously set limit, thus protecting you from unexpectedly high connection
charges.
If you run the LANCOM Router via DSL access with a flat-rate tariff, you can
set the maximum connecting-time in minutes.
Any budget can be deactivated by entering the value '0.'
In basic settings the charge protection is defined to maximum 600
minutes within seven days. Adapt this setting to your personal needs
or deactivate the charge protection if you have arranged a flatrate
with your provider.
3.2
Instructions for LANconfig
Start up LANconfig by clicking Start
LANconfig
LANconfig automatically detects the new LANCOM Router in the TCP/IP
network. Then the setup wizard starts that will help you make the basic
settings of the device or will even do all the work for you (provided a sui-
table network environment exists).
If the setup wizard does not start automatically, start a manual search
for new devices on all ports (if the LANCOM Router is connected via a
serial port) or in the network (Device
If you cannot access an unconfigured LANCOM Router, the problem
may be due to the netmask of the LAN: with less than 254 possible
LANCOM 1811 Wireless DSL – LANCOM 1821+ Wireless ADSL
Chapter 3: Basic configuration
Programs
LANCOM
Find).
35
Advertisement
Table of Contents
