Intermec PD41 Manual page 61

Chapter 3 — Configuring the Printer
46
4 Click Submit Settings.
Use the following table to understand the Alert Settings.
Understanding the Alert Settings
Setting
Label Not Taken
(Fingerprint only)
Cutter Error
Head Lifted
Out of Ribbon
Pause Mode
Setup Mode
Error Condition
(Fingerprint only)
Application Break
(Fingerprint only)
Print Job Complete
(Fingerprint only)
Odometer Count 1
Notification Method The method used to send an alert message. You can
Description
Sent when the printed label is not taken from the
printer. This setting applies to label and ticket media
and requires an optional label taken sensor.
There was an error related to the label cutter.
A printer job was sent to the printer while the
printhead was lifted.
You have thermal transfer ribbon selected and the
printer is out of ribbon.
The printer is in Pause mode.
The printer is in Setup mode.
An error has occurred in the Fingerprint application.
The error does not have to be critical to the print job
for the printer to send this alert.
A running Fingerprint application has been
interrupted manually or because of an error.
The print job has been successfully completed.
The amount of media printed has reached a preset
amount, measured in meters or in number of labels.
The Delay repeat setting represents how often the
alert message will be sent when the preset value is
reached.
choose from mail, SNMP-trap, or both.
PD41 and PD42 Commercial Printer User's Manual