Configuring Smartsystems Settings; Configuring The Printer Using Printset - Intermec PD41 Manual

Chapter 3 — Configuring the Printer

Configuring the Printer Using PrintSet

56
Understanding the 802.1x Settings (continued)
Setting
Server Common Name #1
Server Common Name #2
(TTLS and PEAP only)
Server Certificate
Validation (TTLS and
PEAP only)

Configuring SmartSystems Settings

Use the SmartSystems page to view or change the SmartSystems
server IP address and the master port number.
To configure the SmartSystems settings
1 Click Network Admin > SmartSystems.
2 View or change the settings.
3 Click Submit SmartSystems settings.
PrintSet is a printer configuration tool that allows you to easily
change your setup parameters. You can also use the setup wizards in
PrinSet to guide you through common configuration tasks.
To configure the printer with PrintSet
1 Make sure that you have a PC running Microsoft Windows 98 or
later.
2 Download PrintSet from the Downloads page of the Intermec web
site at www.intermec.com.
3 Connect your printer to your PC using a serial cable. For help, see
"Connecting the Printer to a PC Through the Serial Port" on
page 22.
Description
Specify common names. If you specify one
common name, the server certificate common
name must match this name for
authentication. If you specify two common
names, the server certificate common name
must match at least one of them. The default is
"" (any common name).
Enables certificate validation. Specifies
whether or not to check if the installed CA
certificate is the root of the server certificate.
PD41 and PD42 Commercial Printer User's Manual