Intermec PD41 Manual page 43

Chapter 2 — Connecting the Printer
28
3 If necessary, change the PC serial port configuration to match
your printer:
Parameter
Baud rate
Data bits
Parity
Stop bits
4 Start PrintSet on your PC.
5 In the General Tasks box, click Add Printer and step through the
screens of the Add Printer Wizard until you have successfully
added your printer.
6 In the Printer Tasks box, click Wireless Setup Wizard and step
through the screens to set up wireless network and security
parameters.
To set up the printer for wireless communications using
HyperTerminal
1 Connect one end of the serial cable to the back of the printer and
connect the other end of the cable to a serial COM port on the PC.
2 On your PC, open HyperTerminal and set these serial port
parameters:
Parameter
Baud rate
Data bits
Parity
Stop bits
.
3 From the host PC, check the wireless settings. For help, see
"Manually Configuring IP Settings" on page
If you are using IPL, send these commands to the printer:
<STX><SI>wt,SSID<ETX>
<STX><SI>wt,WEP<ETX>
Default Setting
9600
8
None
1
Default Setting
9600
8
None
1
PD41 and PD42 Commercial Printer User's Manual
25.