Understanding Printer States - Intermec PD41 Manual

Understanding Printer States

PD41 and PD42 Commercial Printer User's Manual
Note: If the printer is running a Fingerprint application, access to
Setup mode is controlled by the application.
The printers can enter various states which indicate the current mode
of operation.
PD41 and PD42 Printer States
State
PUP
Power off
Idle
Running application
Setup mode
Information mode
(i-mode)
Printing
Printing (wait for LTS) The printer is waiting for the label taken sensor to
Paused
Testmode
Extended Testmode
Dumpmode
Upgrading
Error
Explanation
Power-UP (starting up)
The printer is turned off.
The printer is operational and is waiting for print
jobs.
The printer is running a Fingerprint application.
(PD42 only) You can access Setup mode through
the soft keys associated with the screen. Use Setup
mode to change some of the printer settings.
(PD42 only) You can access Information mode
from the soft keys when the printer is idle. In
Information mode, the printer cycles through
some of the interface settings in 5 second intervals.
The printer is printing labels.
indicate that a label has been taken.
The printer is paused during a print job.
The printer is in Testmode. For more information,
see "Using Testmode" on page
The printer is in Extended Testmode. For more
information, see "Using Extended Testmode" on
page 75.
The printer is in Dumpmode, which means it is
listening on all communication ports and prints
incoming characters.
Firmware is being upgraded.
The printer is in an error state.
Chapter 1 — Using the Printer
74.
9