Kenton Control Freak STUDIO EDITION User Manual page 37

CONTROL FREAK
Example of programming a button to learn Note On/Off messages
Press the [–– >] edit button to enter EDIT MODE
Use the Data Wheel to select...
Enter a suitable name as previously described
Press [SHIFT] + [STORE] to jump directly to PB on data.
Press the [LEARN] button
Press and hold a key on your keyboard
Press the [LEARN] button again
Press the [< ––] button to view the button state*
Use the Data Wheel to select
Press the STORE button to save data.
Press the [EXIT] button to return to PLAY MODE
Press the [–– >] edit button to enter EDIT MODE
Use the Data Wheel to select*
Enter a suitable name
Press and hold a key on your keyboard
Press [LEARN]
Release the key on your MIDI controller
Press [LEARN] again
Press the [STORE] key to save your data
Press the [EXIT] key to go back to PLAY MODE
*1 Learn will always insert a 'Set MIDI Chan' command for the MIDI channel the data was received on. If you
want to use the Global channel at this point, press the [DELETE] key.
*2 You could use 'Copy Single' instead. (See page 19). Copy the PB On to PB Off for the same button.Then
edit the PB Off data and change the Note On command to Note Off.
Note: some keyboards/controllers send a 'Note On' message with a Velocity of 0 instead of a 'Note Off'
message.They are functionally identical but the Control Freak will of course show a 'Note On' on these cases,
instead of the 'Note Off' in the example above.
1
2
EDITING EXAMPLES
EDIT`PB``ON`NAME
Note`On`36`C1
Minimum`Levl```0
Learning
WAITING`FOR`DATA
````Note-On
````COMMAND
Set`MIDI`Chan`1
``Header``Data
`Button`ON`only
Button`On+OFF
UPDATING`MEMORY
....
EDIT`PB``ON`DATA
EDIT`PB`OFF`NAME
`Note`Off`36`C1
````Learning
Waiting`for`data
````Note-Off
````COMMAND
Set`MIDI`Chan``1
UPDATING`MEMORY
33