Kenton Control Freak STUDIO EDITION User Manual page 35

CONTROL FREAK
At this point you have already set the slider to send MIDI volume (controller #7) on MIDI Channel #1.
Continue as follows to make it also send inverted data on Channel #2.
Press the [–– >] key – the display will show:
Turn the Data Wheel one click to the left - the display will show:
Press the [–– >] key – the display will show:
Turn the Data Wheel to the left (anti-clockwise) until the display shows:
Press the [–– >] key – the display will again show:
Turn the Data Wheel one click to the right - the display will show:
Press the [–– >] key – the display will show:
Turn the Data Wheel to the right (clockwise) until the the display shows:
Press the [–– >] key – the display will show:
Turn the Data Wheel one click to the left and the display will show
Press the [–– >] key – the display will show:
Press the [STORE] key to save your data
Press the [EXIT] key to go back to PLAY MODE
EDITING EXAMPLES
````COMMAND
``End`of`DATA
Invert`Data````
````COMMAND
``End`of`DATA
Set`MIDI`Chan``2
````COMMAND
``End`of`DATA
```Controller
Controller`Numbr
0``Bank`Select
7``Main`Volume
Controller`Value
Data`Val`00h```0
Data`from`Slider
````COMMAND
``End`of`DATA
UPDATING`MEMORY
31