Installation - DBL Technology GoIP User Manual

Channel "x"

Installation

2
The same installation procedure applies for all models with the differences in the number of channels (ports)
available and the SIM card insertion. It is important to note that the power to the SIM slot MUST BE
disconnected/removed before removing or inserting a SIM Card.
disconnecting the power to the GoIP or shutting each GSM module individually via its built-in web interface.
1. SIM card slots are located either at the bottom (for old hardware) or at the back (for new hardware) of the
main unit.
For the models with the SIM card slots located at the bottom, you need to open the bottom SIM cover in
order to install SIM cards.
Insert a SIM card to each slot carefully and then place the metal clip back in place.
For the models with the SIM card slots located at the back, just insert a SIM card to each slot as shown in
the drawing on the right.
inserting the card.
For GoIP (1-channel), the SIM card insertion orientation is shown in the figure on the right.
contacts must face down and the cut corner is inserted first.
For GoIP-4 and GoIP-8, the SIM card insertion orientation is shown in the figure on the right.
contacts must face up and the cut corner is inserted first.
http://www.dbltek.com
Each GSM channel has its own status LED and its color is green.
1. It blinks at a rate of every 100ms (Fast blink) when the corresponding GSM
channel is not yet registered to a GSM network.
2. It blinks at a rate of every second (Slow blink) when the corresponding GSM
channel is ready for making or receiving calls (registered to a GSM network).
3. It illuminates when GSM call activities occurs (in use, ringing).
First slide the metal clip to the direction as indicated on the top of the clip.
Please make sure that the orientation of the SIM Card is correct before
GoIP User Manual
The power is removed by either
The metal
The metal
7