DBL Technology GoIP User Manual page 48

Three modes for base station selection are available:
1. Auto - This mode uses the default GSM base selection mechanism.
2. Poll - This mode limits the number and the list of base stations (BTS) that could be selected.
Whitelist or Blacklist method can be used for BTS selection.
Parameter
(GSM Base Station)
1. Maximum Polling
Channels
2. Channel Switching
Interval (m)
3. White/Black List Auth
4. Whitelist/Blackllist
3. Fixed - This mode locks the base station to the Cell ID specified.
then press [Save Changes].
refresh the screen then select and enter the desired Cell ID as shown below.
Changes] again to save the Cell ID entered.
http://www.dbltek.com
Description
This limits the maximum number of channels for polling.
This defines the duration in minutes when the next base station switching
should occur. The base station switching only occurs when the
corresponding channel becomes idle.
There are three ways to define how to switch to a different base station.
If it is disabled, the base station selection cycles through the neighbor list.
If the Whitelist authentication mode is selected, then the channel
selection cycles through the base stations defined in the Whitelist.
If the Blacklist authentication mode is selected, then the channels listed in
the Blacklist will not be selected.
Whitelist defines the base stations that are going to be used.
Blacklist defines the base stations that are NOT going to be used.
To view the available Cell IDs, please wait couple of minutes and then
Select "Fixed" to enable this mode and
Remember to press [Save
GoIP User Manual
Either
Default Value
4
30
47