DBL Technology GoIP User Manual page 37

3.3.9Call IN
This page defines how incoming calls to each GSM channel are handled.
answered and prompted for second dial or forwarded to a phone extension or IVR in the VoIP network
connected. The parameters in the Call In Page are divided into two sections.
parameters that are applicable to all channels and the bottom section are for each channel individually.
1. The CID Forward Mode is applicable intended to forward the GSM caller ID to VoIP and for all channels.
Please refer to Appendix E for more details'
2. The Call IN via GSM parameter must be enabled in order to receive GSM incoming calls.
3. The Hunt Group Mode is use to simulate "Call Center" operation where a single GSM number is used for
all incoming calls.
all other channels to "Client".
Group mode not to function properly.
disabled.
4. The Call IN Auth is used authenticate the incoming calls.
setting and the corresponding White list or Black list.
5. The Auto Incoming Call Block is used to block an incoming call when the same number is called
consecutively for more than the limit defined.
that are sent by the carrier.
6. The *Auto Config. Other Line button is provide to facilitate the programming of each channel.
parameters for CH1
channels.
The parameters defined in this section are described in details in the Table below.
Parameter
1. CID Forward Mode
http://www.dbltek.com
To enable this function, set the Hunt Group mode of one GSM channel to "Host" and
Please do not set more than one channel to Host as it may cause the Hunt
are set, clicking this button automatically duplicates the CH1 settings to all other
Description
This specifies the method used to transmit an incoming GSM caller ID to VoIP.
In addition, the GSM Forwarding for all "Client" channels must be
Calls can be accepted or rejected based on this
Customer has requested this feature to block test calls
GoIP User Manual
GSM incoming calls can either be
The top section contact the
Default Value
Enabled
After the
36