DBL Technology GoIP User Manual page 23

7. Re-register Period (s)
8. Outbound Proxy
9. Home Domain
10. Backup Server
 SIP Proxy
 SIP Registrar
 Home Domain
11. Routing Prefix
2. Config. By Line (for all models except GoIP-1) Mode
This mode is only applicable for multi-line models.
channel) registers to a SIP server separately and operates as an independent phone line. A Routing Prefix
for each channel must be assigned in order to enable the channel to allow making outgoing calls.
allows to the SIP server to assign which channel to dial out the call for termination. If a channel does not
have its Routing Prefix set, this channel will not be used to dial out any calls.
the phone number to be dialed out must match one of the Routing Prefixes assigned.
the matching Routing Prefix will be used to dial out the call.
dialed out and a SIP 404 message is returned to the SIP Server.
available to dial out the call, a SIP 503 message is returned to the SIP Server.
Prefix is defined in the Parameter Table for Single Server Mode.
It is important to note that the Routing Prefix (P) must be removed via the dial plan before the number is
dialed out. The dial plan syntax to remove the Routing Prefix is "P:-P|". Please refer to section 3.3.6 for
more information on the Call Out Dial Plan.
http://www.dbltek.com
Register to the SIP Server at an interval specified by this parameter.
The address of the Outbound Proxy used for VoIP communication is specified here.
Home Domain is used in SIP identification. It should be specified as required.
Backup Server improve service reliability and is used only when the primary server fails.
This specifies the backup SIP Server address.
This specifies the backup SIP Registrar Server address.
This specifies the backup Home Domain address.
This parameter is used for call routing. When this is set, the corresponding channel is
only used to dial out a phone number with the matching Routing Prefix.
Syntax:
<Prefix1>,<Prefix2>,<Prefix3>,.....
where Prefix is a text string which consists of digits, alphabets, and special characters.
The maximum length of the Routing Prefix is 120 characters.
Each line (associated with a corresponding GSM
If no match is found, the call will not be
If a match is found but no channel is
GoIP User Manual
60
Disabled
This
In this mode, the prefix of
The channel with
The syntax for the Routing
22