DBL Technology GoIP User Manual page 36

5. Restricted Dial Plan
6. Sleep Interval in between
Calls
7. Sleep Interval Mode
3.3.8Call OUT Auth
The Call Out page defines how each GSM channel handles calls when they are routed from VoIP.
MUST Be defined properly in order to enable each GSM channel to dial out calls based on your requirements.
general, you can achieve the followings.
Parameter
1. Call OUT Auth
2. Whitelist / Blacklist
http://www.dbltek.com
then append "86" to the beginning of the number.
913601234567, the actual number dialed is 8613601234567.
This option forces the GoIP to only dial out the phone numbers that match the rules defined
in the dial plan.
This setting defines an idle interval in between calls.
are allowed to be made via the GSM channel.
This parameter defines the condition of a call when the Sleep Interval is activated.
1. Any Calls - The Sleep interval is activated whenever an outgoing call is dialed regardless
whether the call is completed successfully or not.
2. Answered Calls - The Sleep Interval is activated whenever an outgoing call is answered.
Description
This parameter defines how incoming VoIP calls are authenticated before dialing them out
via the GSM network. Five options are available:
1. None – No authentication is required.
network.
2. Password – The caller is prompted for entering the password before the call is dialed
out.
3. Whitelist – This is part of the Call Screen function.
the Whitelist list are allowed to dial out via the device.
4. Password or Whitelist – Either the password or the Whitelist authentication method will
be used.
5. Biacklist – The caller numbers listed on this list are rejected.
Both Whitelist and Blacklist for call screening are supported.
entries.
1. Whitelist – This list contains a list of caller numbers that are allowed to use the device
to make outgoing GSM calls when Call OUT Authentication is set to "Whitelist" or
"Whitelist + Password".
Remark: Adding a "#" digit in front of an Whitelist entry enables a special call back
function. When the caller ID of an incoming call is matched, the device first drops
the call and then call back the caller automatically to allow the caller to dial a phone
number.
2. Blacklist – This list contains a list of caller numbers that are rejected by the device to
make outgoing GSM calls when Call OUT Authentication is set to "Blacklist".
If the Callee Number is
During this interval no outgoing calls
Calls are always dialed out via the GSM
Only the caller numbers listed on
Each list contains up to 15
GoIP User Manual
This section
In
Default Value
None
35