Sms In Box; Gsm Channel Control - DBL Technology GoIP User Manual

The procedures to send a SMS are:
a) Select the Line (GSM channel) that you want to send a SMS.
number are displayed.
same SMS is sent via all channels provided that they are in the Login Status.
b) Enter the recipient's phone number (GSM)
c) Type the SMS message in the SMS Content box.
characters for 7/8-bit ASCII code and 70 characters for 16-bit Unicode) .
d) Click [Send] to send out the SMS.

SMS In Box

3.4.5
Click [SMS In Box] to view the SMS messages received as shown below.
the latest 5 messages received for the corresponding GSM channel.

3.4.6GSM Channel Control

This feature is implemented for two functions:
1. Removing the power to a GSM channel before removing or inserting a SIM card.
recommended procedure in order to prevent damages to the SIM card.
2. Disabling a GSM channel temporary.
Click [GSM Channel Shut Down] to access the webpage below to shut each GSM module individually.
Place a check mark ( ) to select the desired channel and then click [Save] to activate the shut down.
Remove the check mark and then click [Save] to turn on the channel again.
selection is a short cut to turn on or to shut down all channels.
http://www.dbltek.com
.
The last option "All Lines" means that all channels are selected and the
The line status and the SIM (GSM)
The maximum length of a message is 140
Select the desired line to view
GoIP User Manual
This is the
The "All Channels"
51