DBL Technology GoIP User Manual page 22

a) All Routing Prefixes are set
- Try to match the number received for making an outgoing call against the Routing Prefix of each
channel.
call.
channels is selected.
message.
b)Only some Routing Prefixes are set
- Try to match the number received for making an outgoing call against those Routing Prefixes
that are set.
outgoing call.
matched channels is selected.
is used to make the call. Otherwise, the call is rejected by sending back a SIP 503 message.
c) None of the Routing Prefixes are set
- An idle channel is selected to dial out the call. If no idle channel is available, the call is rejected
by sending back a SIP 503 message.
It is important to note that the Routing Prefix (P) must be removed via the dial plan before the number is
dialed out. The dial plan syntax to remove the Routing Prefix is "P:-P|". Please refer to section 3.3.6 for
more information on the Call Out Dial Plan.
Parameter
(Single Server Mode)
1. Phone Number
2. Authentication ID
3. Display Name
4. Password
5. SIP Proxy
6. SIP Registrar
http://www.dbltek.com
If only one match is found, the corresponding channel is used to make the outgoing
If more than one matches are found, the best available channel among the matched
If no match is found, the call is rejected by sending back a SIP 503
If only one match is found, the corresponding channel is used to make the
If more than one matches are found, the best available channel among the
Description
This is the SIP number used by the device.
The name of the device used in Caller Identification is defined here.
The Authentication ID used for SIP registration is specified here.
The password used for SIP registration is specified here.
The domain name or IP of the SIP Proxy or Server is specified here. If the SIP Proxy is
using the standard 5060 signaling port, then there is no need to specify the port
number. Otherwise, the port number can be specified by adding ":" and then the port
number at the end of the SIP Proxy address.
The address of the SIP Registrar Server is specified here.
If no match is found, an idle channel without a Routing Prefix
GoIP User Manual
Default Value
21