DBL Technology GoIP User Manual page 26

Gateway3) specified and then dial out the call via an Idle channel that is used the least (in terms of the
number of calls dialed). The last part of the SIP Trunk Gateway IP addresses can be specified as "X" or "x"
to represent that the whole segment IP addresses (0 - 255).
accepted.
Example: SIP Trunk Gateway2 = 123.124.125.x
This example shows that Calls originated from 123.124.125.0 to 123.124.125.255 are accepted.
Call routing to a GSM channel is now based on the Routing Prefix of each GSM channel (Line x).
channel selection algorithm is the same as the one described in the Single Server Mode.
the Routing Prefix is defined in the Parameter Table for Single Server Mode.For received GSM calls, they
will be routed to SIP Trunk Gateway1 provided that an unique IP is used.
SIP Registration is only supported for SIP Trunk Gateway1.
required. The Re-Register Period must be set to a non-zero value. If SIP Registration is not required, the
Re-Register Period must be set to zero.
The parameters available in this mode are listed in the table below.
Parameter
(Trunk Gateway mode)
1. SIP Trunk Gateway1
2. SIP Trunk Gateway2
3. SIP Trunk Gateway3
SIP Registration to Trunk Gateway1
Some Trunk gateway connection requires a SIP registration which can be defined via the following parameters.
4. Phone Number
5. Authentication ID
6. Password
7. Re-register Period (s)
3.3.4Advanced VoIP
The parameters in the Advance VoIP section are common for all configuration modes.
parameters are preconfigured with factory defaults. Users should only modify the parameters required.
http://www.dbltek.com
Description
This specifies the first SIP Trunk Gateway address. Use "X' or "x" for
the last part of the address to specify the entire segment (0 - 255).
This specifies the second SIP Trunk Gateway address. . Use "X' or "x"
for the last part of the address to specify the entire segment (0 - 255).
This specifies the third SIP Trunk Gateway address. . Use "X' or "x" for
the last part of the address to specify the entire segment (0 - 255).
This specifies the phone number for the SIP registration.
This specifies the authentication ID for the SIP registration.
This specifies the password for the SIP registration.
This specifies the period for sending a re-registration request.
Calls originated from the IP segment are
Fill in the SIP registration information as
GoIP User Manual
The
The syntax for
Default Value
0
In general, these
25