Konica Minolta 2300 Service Manual page 94

(2) Replacement of the Image Transfer Belt Unit
4131D061AA
(3) Replacement of the Toner Cartridge
C4131o018AA
C4131o021AA
1. Open the Front Door.
2. Remove the Waste Tonner Bottle.
3. Remove the Drum Cartridge.
4. Remove two screws and the Image Transfer Belt
Unit.
NOTE
When replacing the Image Transfer Belt Unit, be sure
to remove the packing materials.
Do not touch the transfer belt with bare hands.
5. To reinstall the belt unit, reverse the order of
removal.
6. Select functions as follows: Service -> Service/
Service Person -> Reset Counter/Fuser Unit.
Then, clear the counter.
1. Open the Front Door.
2. Remove the Waste Tonner Bottle.
3. Remove the Drum Cartridge.
NOTE
Discard the Toner Cartridge according to the applica-
ble local regulation. Do not throw the Toner Car-
tridge into an open flame.
4. Remove the packing materials and install the
Toner Cartridge.
5. Enter the capacity of the Toner Cartridge just
installed through the control panel.
E.g.: If a Yellow Toner Cartridge has been
replaced (4.5 K)
"Menu/Engine -> Replace Toner -> Yellow ->
High"
94