Konica Minolta 2300 Service Manual page 114

4131D069AA
4131D070AA
4131D071AA
(6) Removal of the Turnover Motor And The Transport Motor
4131D075AA
4131D076AA
11. Snap off one E-ring and remove the cam from the
inside of the printer.
12. Remove five screws and the Rack Drive Assy.
13. Snap off one E-ring. Then, remove the Rack
Clutch Shaft and the Drive Gear.
14. Remove two screws and the Rack Motor.
1. Remove one screw and the Protective Cover.
2. Remove the harness and connector.
3. Remove two screws and the Duplex Unit Control
Board.
114