Konica Minolta 2300 Service Manual page 135

(4) Service menu
A six-digit number indicating the number of pages that have been printed
FACE COUNT
until now with this printer is displayed.
CONTROLLER
The controller firmware version is displayed.
VER.
ENGINE VER. The printer engine firmware version is displayed.
A complete DIMM test is performed, allowing you to check that there are no
DIMM TEST
errors in the DIMM.
A complete SDRAM test is performed, allowing you to check that there are
SDRAM TEST
no errors in the SDRAM.
A Power On test is performed. Wait until the test is finished and "IDLE" is dis-
POWER ON TEST
played.
RESET COUNTER
Use this after replacing the transfer unit.
TRANSFER UNIT
The settings for Energy Saver, Auto Continue and Chaining Tray are
returned to their defaults.
RESTORE USER The default settings are listed below.
DEFAULT Energy Saver: 30 minutes
Auto Continue: On
Chaining Tray: On
(5) Network menu
• If the printer is connected and used on a network, the following settings should be speci-
fied.
• For details about each setting, contact your network administrator.
Set the IP address of this printer on the network.
IP ADDRESS
Using the Up, Down, Prev. and Next keys, enter the value.
Set the subnet mask value of the network.
SUBNET MASK
Using the Up, Down, Prev. and Next keys, enter the value.
If a router is used on the network, enter the IP address of the router.
GATEWAY
Using the Up, Down, Prev. and Next keys, enter the value.
The Ethernet hardware address for this printer can be seen. (It cannot be
HW ADDRESS
changed.)
HTTP This specifies whether or not PageScopeLight can be accessed.
SNMP This specifies the access privileges for the MIB file.
DHCP: If there is a DHCP server on the network, set whether or not the IP
address is automatically assigned by the DHCP server and other network
information is loaded.
DHCP/BOOTP
BOOTP: Set whether or not the IP address is automatically assigned by
BOOTP and other network information is loaded.
Either can be set to "On" or both can be set to "Off".
(6) Consumable Usage menu
BLACK TONER
Indicates the percentage of black toner remaining in the cartridge.
XXX% REMAINING
YELLOW TONER
Indicates the percentage of yellow toner remaining in the cartridge.
XXX% REMAINING
135