Konica Minolta 2300 Service Manual page 101

(1) Removal of the Rear Cover
1. Remove the Rear Cover
4131D007AB
(2) To replace the Master Board
Note
• When replacing the master board, be sure to move the EEPROM from the old master
board to the new one.
1. Remove the rear cover and the master board.
2. Replace the EEPROM (IC3).
(New)
4131D059AB
2. Remove the harness and connector.
3. Remove five screws and the Master Board
(PWB-A).
NOTE
When the Master Board has been replaced, be sure
to demount EEPROM from the old master board and
mount it to the new one.
(Old)
Note
Be sure to install the EEPROM so that it
faces the correct direction.
101
4131D056AB