Contact Your Dealer - Christie CP2210 Setup Manual

Wear Protective Clothing
Never open the lamp door unless you are wearing authorized protective clothing such as that included in a
Christie Protective Clothing Safety Kit (P/N: 598900-095). Recommended protective clothing includes, but
may not be limited to a polycarbonate face shield, protective gloves, and a quilted ballistic nylon jacket or a
welder's jacket. NOTE: Christie's protective clothing recommendations are subject to change. Any local or
federal specifications take precedence over Christie recommendations.
Cool the Lamp Completely
DANGER
clothing whenever lamp door is open or while handling lamp. 2) Ensure those within the
vicinity of the cinema projector are also suited with protective clothing. 3) Never attempt to
access the lamp while the lamp is ON. Wait at least 10 minutes after the lamp turns OFF
before powering down, disconnecting from AC and opening the lamp door.
The arc lamp operates at a high pressure that increases with temperature. Failure to allow the lamp to
sufficiently cool prior to handling increases the potential for an explosion causing personal injury and/or
property damage. After turning the lamp OFF, it is crucial that you wait at least 15 minutes before disconnect-
ing AC and opening the lamp door. This provides enough time for the cooling fans to properly cool the lamp.
Ensure the lamp is completely cooled before handling and always wear protective clothing!
For all other precautions critical for safe removal and replacement of the lamp, see
page 6-4.
1.5

Contact Your Dealer

If you encounter a problem with your Christie cinema projector, contact your dealer. Typically, servicing is
performed
on site. To assist with the servicing of your cinema projector, enter the information in the tables and keep this
information with your records.
Table 1.1 Purchase Record
Dealer:
Dealer or Christie Sales/Service
Contact Phone Number:
cinema projector Serial
Number*:
Purchase Date:
Installation Date:
* The serial number can be found on the license label located on the front panel.
Table 1.2 Ethernet Settings
Default Gateway:
cinema projector IP Address:
Subnet Mask:
CP2210 Setup Guide
020-100524-04 Rev. 1 (05-2014)
Lamp may explode causing bodily harm or death. 1) Always wear protective
Introduction
6.8 Replace the Lamp, on
1-3