Exiting The Setup Menus - IBM Network Color Printer Administrator's Manual

Choosing Parallel Setup Options
Parallel Setup Notes
Select YES to enable and configure the printer's parallel
YES (default) port.
NO
Timeout Notes
• If you will be sending TIFF files and PostScript files
in binary format, enter a number of seconds. Files
15 (default)
in binary format lack a unique end-of-file character.
Leave blank or
For these files, the timeout will signal the end of the
enter a number
between 5 and file.
60.
• If you will be sending TIFF files and PostScript files
in ASCII format, leave blank.
Ignore EOF Notes
• If you will be sending TIFF files and PostScript files
in binary format, select YES.
NO (default)
The printer will ignore end-of-file characters.
YES
• If you will be sending TIFF files and PostScript files
in ASCII format, select NO.
The printer will use end-of-file characters to signal
the ends of files.

Exiting the Setup Menus

Exit Setup Notes
• Select YES if you are done configuring the printer.
NO (default)
• Select NO to go back into the setup menus.
YES
Notes
Save Changes
• Select YES to save the changes you have made to
the printer configuration.
YES (default)
• Select NO to return the printer to the configuration
NO
it had when you started.
6–24
Administrator's Guide
The following table summarizes parallel setup options.
Table 9: Network Setup Options: Parallel
While in the Setup menus, if you repeatedly press the Menu push button, the
printer skips through the other menus directly to this one. Use this menu to
save or not save the changes you have made and to exit the Setup menus.
Table 10: Exit Setup and Save Changes
If you accessed the Setup menus during a power-up sequence, the printer
will initialize your changes and continue with the power-on sequence. If you
accessed the Setup menus by pressing the Online push button, press it
again now. The printer initializes any changes you have made and comes on
line.