Contents; Order Of Installation Events - Thinklogical DCS StudioPRO Product Manual

3.2.

Contents

When you receive your Thinklogical StudioPRO Extender system, you should find the following items:

StudioPRO Extender – Transmitter

StudioPRO Extender – Receiver

AC Power Supply (PWR-000022-R) – Quantity 2

USB Cable, 6 Feet (for the Transmitter unit)

DVI Video Cable, 2 Meters
All physical connections to the product use industry-standard connectors.
3.3.

Order of Installation Events

In order to properly use the SPE system, you must follow this order of events for the initial power-up. By
proceeding in this order, your monitor's DDC2B signal (if any) will be sent through the SPE connection
upon power-up.
1. Plug fiber into T (L1) location labeled on the Transmitter unit. Plug that corresponding end of
fiber into R (L1) location labeled on the Receiver unit or StudioPRO DCS.
2. Plug fiber into R (L2) location labeled on the Transmitter unit. Plug that corresponding end of
fiber into T (L2) location labeled on the Receiver unit or StudioPRO.
3. Plug fiber into R (L3) location labeled on the Transmitter unit. Plug that corresponding end of
fiber into T (L3) location labeled on the Receiver unit or StudioPRO.
4. FOR DUAL-LINK MODEL ONLY: Plug fiber into R (L4) location labeled on the Transmitter unit.
Plug that corresponding end of fiber into T (L4) location labeled on the Receiver unit or
StudioPRO.
5. Connect the power supply to the Transmitter and plug corresponding end into a suitable AC
power source.
6. Connect the power supply to the Receiver and plug corresponding end into a suitable AC power
source.
7. Connect your PC to the USB location (USB Type B Connector) labeled on the Transmitter unit.
Connect your PC Video to the DVI location (DVI Connector) labeled on the Transmitter unit.
8. Connect your devices(s) into the device port(s) (USB Type A Connector) on the Receiver unit.
Connect your DVI Display into the DVI location (DVI Connector) labeled on the Receiver unit.
MAN-000018 8 REVISION A