Thinklogical DCS StudioPRO Product Manual page 16

Connect your fiber cable to the ST-type connector on each SPE pair (one Transmitter and one
Receiver). Dress the cable so it will not get crushed, pinched or otherwise damaged.
When connecting the fiber optic cables, you must be sure to:
 Connect the fiber connector labeled 'L1 (T)' on the Transmitter to the fiber connector
labeled 'L1 (R)' on the Receiver.
 Connect the fiber connector labeled 'L2 (T)' on the Transmitter to the fiber connector
labeled 'L2 (R)' on the Receiver.
 Connect the fiber connector labeled 'L3' on the Transmitter to the fiber connector
labeled 'L3' on the Receiver.
 Connect the fiber connector labeled 'L4' on the Transmitter to the fiber connector
labeled 'L4' on the Receiver.
L 3 L4 L1
T
DVI FROM CPU DVI LOCAL DISPLAY USB 1 . 1
DUAL LINK DUAL LINK
SPE-DL1.1
transmitter
*Note: When you connect the fibers, THE FIBER CABLE SHOULD NOT BE CROSSED.
3.3.2. Digital Video (DVI-D) Input – Transmitter
The SPE Transmitter unit connects to your DVI video source (DVI-D video card) using the provided DVI-
D male-to-male cable (CBL000013-002MR). The Digital Video Input connector on the transmitter will
NOT accept other form factors of DVI connectors (DVI-I or DVI-A).
3.3.3. Digital Video (DVI-D) Output - Receiver
The SPE Receiver unit connects to your DVI video monitor, projector, or other viewing device. Your
device must have a DVI-D connector on its cable.
MAN-000018
L2
R 5VDC
POWER
Figure 6: Proper Connection of Fiber Cable Shown
10
L4 L 3 L2
T
DVI TO DISPLAY USB 1. 1
DUAL LINK
SPE-DL1.1
receiver
REVISION A
L1
R 5VDC
POWER