Install The Wing Panels - GREAT PLANES SU-31 Instruction Manual

o
9. Fit the clevises on the aileron pushrods into the outer
holes of the aileron control horns and servo arms as shown.
(You may need to temporarily remove the servo arms from
the servos.) With the servo arms parallel to the hinge lines
and the ailerons in the neutral positions, center the length
of the pushrods between the two clevises. When satisfied,
lock the clevises onto the pushrods by threading a 2 x 4mm
screw into each clevis screw hole. The screw head should fit
into the recessed hole in the adjustable clevises as shown
(installing the screws in the wrong direction may not properly
tighten the clevises onto the pushrods).

INSTALL THE WINg PANELS

o
1. Trim the covering in the fuselage for the wing tube, wing
mounting hooks, servo lead holes and anti-rotation pin.
o
2. Glue the 3 x 15mm carbon anti-rotation pins halfway
into the holes in the wing root ribs using medium CA glue.
o
3. Slide the carbon wing tube into the wing tube channel
in the fuselage and center its position.
o
4. Slide the wing panels onto the wing tube and push them
in place against the fuselage sides by fitting the anti-rotation
pins into their mating holes. Secure the wing by hooking one
end of a rubber band to one wing hook, wrapping the rubber
band around the other wing hook and returning the rubber
band to the original wing hook. Further secure the wing with
a second rubber band, installing it in the same manner.
8 8