Table of Contents
Advertisement
In the "ASSEMBLE THE WING PANELS" section, starting
on page 7, the steps are incorrectly numbered, however,
all steps are included and should be followed in the
order that they appear.
This step replaces Step 4 on Page 13.
o
4. Install the elevator pushrod in the same manner using
the remaining 6-3/4" [170mm] pushrod. Use some diagonal
cutters or a rotary tool to trim the pushrod so that it extends
1/2" [13mm] past the clevis.
Entire Contents © Copyright 2009
TECHNICAL NOTICE
In the "MOUNT THE MOTOR, ESC & RECEIVER" section,
starting on page 14, the steps are incorrectly numbered,
however, all steps are included and should be followed
in the order that they appear.
This step replaces the first Step 4 on Page 15.
o
4. Once the epoxy has had plenty of time to cure, remove
the tape and install the motor using the "X" shaped mount
provided with the motor. Secure the motor to the motor mount
with four 3 x 8mm machine screws and 3mm washers. Do
not forget to use threadlocking compound when installing
the "X" mount to the motor and when installing the motor to
the airplane.
1
GPMA1547 Tech Notice 01
Advertisement
Table of Contents
