Table of Contents
Advertisement
o
12. To install the hatch, slide the dowels into the former
at the front of the airplane. Then press the hatch against the
fuselage and slide it rearward. When it is installed properly
there should not be a gap between the aft end of the hatch
and the fuselage.
INSTALL THE COWL, CANOPY & SPINNER
o
1. Prepare the inside of the cowl by lightly scuffing it with 220-grit
sandpaper. When satisfied, clean the inside with alcohol.
o
2. Glue the four plywood magnet back pieces to the cowl
ring. Note: Pay attention to the position of the cowl magnet
mounting holes in the photograph. The cowl ring is designed
so that it is locked in place with the hatch dowels. Do not glue
the magnet back pieces over the lower cowl ring holes.
o
3. Glue a magnet into each of the four holes in the cowl
ring by coating the insides of the holes with medium CA. Let
the CA glue cure without accelerator.
o
4. Glue four magnets into the holes in the fuselage as
shown. Be sure that the magnets are glued with the
16
Advertisement
Table of Contents
