Table of Contents
Advertisement
❏
3. Slide the wood motor mounts in place on the wing.
Secure them to the wing with two 4-40 x 1/2" [13mm] screws
and two #4 washers for each motor mount. Be sure to apply a
couple of drops of thread locker to each of the screws before
installing the screws.
❏
4. Assemble the motor, prop adapter and motor mount as
instructed in the instructions that came with the motor. Mount
each motor to the motor mounts with three 4-40 x 1/4" [6mm]
screws for each of the motors. Be sure to apply a couple of drops
of thread locker to each of the screws before installing them.
❏
5. Locate the 1/8" x 3/4" [3mm x 19mm] wood dowels. Glue
them into the holes in the leading edge of the wing, making
sure that approximately 1/2" [13mm] of each dowel extends
from the wing.
Install the Aileron Servos and
Join the Wing Panels
❏ ❏
1. Remove the aileron servo cover from the bottom of the
right wing. Locate one of the plywood servo mounting plates
and position it between the markings on the servo cover. DO
NOT glue them together yet!
7
Advertisement
Table of Contents
