Canon GP160DF Service Manual page 604

CHAPTER 5 SELF DIAGNOSIS
## 0282 [TX] Limit for the number of protocol signal re-transmissions is exceeded during
transmission
• The line condition is poor. After EOM output
the appropriate signal can not be received
because the image signal or EOM signal is
not being properly transmitted.
##0283 [TX] Limit for the number of protocol signal re-transmissions is exceeded during trans-
mission
• The line condition is poor. After MPS output
the appropriate signal can not be received
because the image signal or MPS signal is
not being properly transmitted.
5-16
Cause
Cause
Countermeasure
(1) Raise the modem output level in #2
MENU parameter 007, so the other
party's machine can properly receive the
image signal or EOM signal.
(2) Lower the Tx start speed in user mode
system settings.
(3) Adjust the NL equalizer in #2 MENU
parameter 005, so the other party's
machine can properly receive the image
signal or EOM signal.
(4) Add an echo protect tone to the V29
modem signal in #1 SSSW-SW03 Bit 1.
Countermeasure
(1) Raise the modem output level in #2
MENU parameter 007, so the other
party's machine can properly receive the
image signal or MPS signal.
(2) Lower the Tx start speed in user mode
system settings.
(3) Adjust the NL equalizer in #2 MENU
parameter 005, so the other party's
machine can properly receive the image
signal or MPS signal.
(4) Add an echo protect tone to the V29
modem signal in #1 SSSW-SW03 Bit 1.