Canon GP160DF Service Manual page 398

CHAPTER 13 TROUBLESHOOTING
#0005 [TX/RX] Initial identifier (T0/T1) time over
• TEL LINE TYPE setting mistake.
• Time until connection with the other party's
machine is long.
• Other party's machine does not respond.
• A significant signal cannot be detected after
DIS signal transmission is completed.
• Other party's machine's communication
mode does not match.
(1) Other party's machine mis-operates due
to echo at transmission.
(2) Mis-operation due to echo at reception.
#0008 [TX] Password rejected at polling transmission
• Other party's password and your machine's
password do not match.
#0009 [RX] Jam/Add paper
• Paper is jammed.
• Paper has run out.
• Internal mechanism fault.
13-164
Cause
Cause
Cause
COPYRIGHT © 1999 CANON INC.
Countermeasure
• Set TEL LINE TYPE correctly.
(1) Add a long pause when registering an
autodial entry and delay the timer start.
(2) Increase the T0 timer by #3 NUMERIC
Param. 010 so it won't time out.
• Contact the other party and have the cause
investigated.
• Increase the T1 timer by #3 NUMERIC
Param. 011 so it won't time out.
• No countermeasure possible because the
communications mode is a specification of
the machine.
• See #1 SSSW SW03 for echo countermea-
sures.
Countermeasure
(1) Contact the other party and synchronize
the passwords.
(2) Make a DAT recording of the communi-
cation protocol and analyze it.
Countermeasure
• Remove the paper jam.
• Set more paper.
(1) Check the Add paper sensor, pick-up
sensor, registration sensor, leading edge
sensor and delivery sensor flags.
(2) Check by TEST MODE/FACULTY
TEST/[3]SENSOR TEST.
(3) Check according to this manual's
Feeding fault countermeasures.
(4) Replace the DC controller circuit.
CANON GP160 REV.0 FEB. 1999 PRINTED IN JAPAN (IMPRIME AU JAPON)