Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 14

FIGURE 18
1 Ridge FIGURE 19
TOP
2 Ridges
BOTTOM
FIGURE 20
FIGURE 21
STEP 6 Rear Ankle Bar Assembly
Assemble the Rear Ankle Bar onto the Main Shaft
• Locate the Rear Ankle Bar Assembly Hardware Kit (HK1003).
• With the two ridges of the pre-assembled Heel Cup on the bottom, insert the Rear Ankle Bar
into the large hole at the back of the Main Shaft (Figure 18).
• Insert the bolt from the rear of the Main Shaft to secure the Rear Ankle Bar (Figure 18), and
fasten with the washer and nut using the wrenches provided.
• Slide the separate heel cup, with the two ridges on the bottom, onto the open
end of the Rear Ankle Bar (Figure 19).
TIP: To assist with assembly, repeatedly rotate the Heel Cup while pushing it onto the Rear
Ankle Bar.
• Align the pre-drilled screw hole in the Rubber Plug with the screw hole in the Rear Ankle Bar.
Insert the Rubber Plug into the open end of the Rear Ankle Bar (Figure 20).
TIP: You may want to use a rubber mallet to assist with assembly.
• Secure the Rubber Plug with the screw using the screwdriver provided (Figure 21). If the
screw does not tighten easily, you may need to reposition the alignment of the Rubber Plug.
13