Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 12

STEP 4
FIGURE 12
FIGURE 13
FIGURE 14
FIGURE 15
Attach the Table Bed to the A-Frame
• Face the front of the A-Frame where the Crossbar is located (refer to Figure 12 to determine
A-Frame Front).
• Grasp both the Roller Hinges, right above the Cam Lock, and lift the Table Bed. Allow the top
of the Table Bed to rotate toward the floor, so that the back of the Table Bed is now facing
you and the top of the Table Bed is in front of the Crossbar (Figure 13).
• Lower each Roller Hinge Pivot Pin into the A-Frame hinge plates, one side at a time
(Figure 14). The Self-Locking Hooks will open to allow the Pivot Pin into the Hinge Plate slot,
then automatically snap closed over the Pivot Pin.
TIP: You may need to push outward on the Hinge Plate in order for the second Pivot Pin
to lock in place.
• Make sure that each Pivot Pin is seated at the base of the slot in the Hinge Plates, and that
the Self-Locking Hooks have closed over both Pivot Pins (Figures 14a & 14b).
FIGURE 14a FIGURE 14b
TOP VIEW
INSIDE VIEW
• Rotate the Table Bed into the use position (Figure 15). Ensure that it rotates smoothly.
Failure of the Self-Locking Hooks to close over both Roller Hinge
Pivot Pins is an indication of improper assembly and if not corrected
11
WARNING
!
could result in serious injury or death!