Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 16

STEP 8
FIGURE 25
FIGURE 25a
FIGURE 26
FIGURE 27
Assemble the Main Shaft to the Table Bed
• Facing the front of the A-Frame, hold the Main Shaft in your left hand with the height
markings facing up. Slide the end of the Main Shaft into the Main Shaft Housing (Figure
25), located at the base of the Table Bed.
• With your right hand, pull out the Height-Selector Locking Pin (Figure 25a) to allow the
Main Shaft to slide in further and release in the desired height setting. Refer to the Owner's
Manual for more information on selecting your height setting.
• The Main Shaft MUST REST against the Crossbar of the A-Frame (Figure 26).
IMPORTANT: The Crossbar prevents the Table Bed from rotating forward when the user
steps on the Ankle Comfort Dial. If the Main Shaft does not rest on the Crossbar as shown
in Figure 26, then the Table Bed has been assembled backwards onto the A-Frame.
This MUST BE CORRECTED before use.
• Test the inversion table by hand for smooth and steady rotation (Figure 27) and ensure that
all fasteners are secure.
15