Teeter Hang Ups ComforTrak EP-560 Assembly Instructions Manual page 9

STEP 1 Stretch-and-Grip Base & Stretch Assist Handle Assembly
FIGURE 1
RIGHT LEFT
1 Spreader Arms 2 Crossbar
FIGURE 2
FIGURE 3
Open the Stretch-and-Grip Base ("A-Frame")
• On a level surface, position the A-Frame so that it is standing upright and the Stability Feet
are on the ground.
• Gently push down on the Spreader Arms to ensure they are fully open and in the "locked"
position (Figure 1).
• Look for these temporary labels on your A-Frame, designed to assist you with the remainder
of the assembly process. You may choose to remove them after you assemble your
inversion table.
RIGHT Indicates right side as you are using the inversion table, not facing it.
LEFT Indicates left side as you are using the inversion table, not facing it.
BACK Indicates the back of the A-Frame / fully assembled inversion table.
FRONT Indicates the front of the A-Frame / fully assembled inversion table.
Assemble the Stretch Assist Handles
• Locate the Stretch Assist Handle Assembly Hardware Kit (HK1008).
• Determine the left or right handles, marked with an embossed L / R on the inside of the black
plastic part of each handle.
• Align the black plastic part of the corresponding handle (left / right) over the outside edge of
the Hinge Plate on the A-Frame (Figure 2).
• Insert and loosely hand-tighten three of the Allen Head Screws through the Hinge Plate into
the handle (Figure 3).
• Repeat with other handle. Tighten all fasteners with the Allen Wrench provided, being careful
not to over-tighten.
8